Ricoh SP 4510 DN User Manual page 81

Message
"Cannot connect with the
wireless card. Turn the main
power switch off, then check the
card."
"Cannot print because both the
main and designation (chapter)
sheets are set to the same paper
tray. Press [Job Reset] to cancel
the job."
"Hardware Problem: Ethernet"
"Hardware Problem: HDD"
Cause
• The wireless LAN interface
board was not inserted
when the printer was
turned on.
• The wireless LAN interface
board was pulled out after
the printer was turned on.
• The settings are not
updated although the unit
is detected.
The tray selected for other
pages is the same as the one for
slip sheets.
An error has occurred in the
Ethernet interface.
An error has occurred in the
hard disk.
When Messages Are Displayed
Solution
• Turn off the main power
switch, and then confirm
the wireless LAN interface
board is inserted correctly.
For details about installing
the board, contact your
service representative.
• If the message appears
again, contact your service
representative.
Reset the job. Be sure the tray
you select for slip sheets is not
providing paper for other
pages.
Turn the main power switch off
and then back on again. If the
message appears again,
contact your service
representative.
• Turn the main power switch
off and then back on
again. If the message
appears again, contact
your service
representative.
• The hard disk may have
not been installed properly
if you have installed it
yourself. Check that it is
properly installed For
details about installing the
unit, see "Installing the
Memory Expansion Units",
Operating Instructions.
79