Ricoh SP 4510 DN User Manual page 78

3. Troubleshooting
Message
"Independent-supply toner"
"IPv6 Address already exists Link-
local Address(109/209)"
"IPv6 Address already exists Stateless
Address(109/209)"
"IPv6 Address already exists Manual
Config. Address(109/209)"
"Load paper in (tray name)"
"No privileges to use funct."
"Option RAM Error"
"Par. I/F board has a problem."
"Printer Font Error."
"Problem with Hard Disk Please call
service."
76
Cause
Independent-supply toner is
set.
The same IPv6 address is
already used.
The same IPv6 address is
already used.
The same IPv6 address is
already used.
There is no paper in the
specified tray.
The logged in user does not
have the privileges to register
programs or change the
paper tray settings.
The printer cannot detect an
optional SDRAM module.
The printer's self-diagnostic
test failed due to a loopback
error.
There are problems with the
printer's font file.
The printer cannot detect the
hard disk.
Solution
Use the toner recommended
for this printer.
Contact your network
administrator.
Contact your network
administrator.
Contact your network
administrator.
Load the specified paper in
the tray, press [JobReset] to
reset the job.
For details about how to set
permissions, see Security
Guide.
Check that the SDRAM
module installed correctly.
Replace the IEEE 1284
board that caused the error.
Turn the printer off, and then
turn it on again.
If the problem persists,
contact your sales or service
representative.
Check that the hard disk
installed correctly. If the
problem persists, contact
your sales or service
representative.