Ricoh SP 4510 DN User Manual page 80

3. Troubleshooting
Message
"Standard Tray is full. Remove the
paper."
"Supply order has failed."
"This NetBIOS name is already in use.
(108/208)"
"The same IPv4 Address already
exists.(102/202)"
"The selected job has already been
printed or deleted."
"USB has a problem. Please call
service."
"Values set for IPv6/Gateway
addresses are invalid.(110/210)"
"Waste Toner almost full"
"Waste Toner full"
"WPA Auth. incomplete.(211)"
78
Cause
The standard tray is full.
The automatic supply order
failed.
The NetBIOS name specified
for the printer is already used
by another device on the
network.
The IPv4 address specified
for the printer is already used
by another device on the
network.
This message might appear if
you print or delete a job from
Web Image Monitor.
The printer has detected a
USB board failure.
The IPv6 address or gateway
address is invalid.
The print cartridge must be
replaced when the life of the
waste toner is ending.
The waste toner is full.
WPA authentication could
not be completed.
Solution
Remove the paper.
The message indicates the
printer tried to order the
supplies.
Contact your network
administrator.
Contact your network
administrator.
Press Exit on the message
screen.
Turn the printer off, and then
turn it on again. If the
problem persists, contact
your sales or service
representative.
Check the network settings.
Prepare a new print
cartridge.
For details, see "Replacing
the Print Cartridge",
Operating Instructions.
Contact your network
administrator.