Table of Contents
Advertisement
OPTIONAL DRIFTWOOD LOG SET INSTALLATION
Read the instructions below carefully and refer to the images. If the logs are broken do not use the unit until they are replaced. Broken
logs can interfere with pilot operation.
Improper positioning of the logs may create carbon build-up and can alter the unit's performance which is not covered under warranty.
*Satin black paint is included if touch ups are required.
1
Rear Log
2
Left Log
3
Right Log
4
Left Cross Log
5
Right Cross Log
6
Front Left Log Piece
7
Front Right Log Piece
Lava embers
Pilot Hood - HZ54E only
Log placement template - one each HZ54E /HZ40E
4
5
1. S hut off gas and electrical supply, allow unit to cool to room temperature.
2. Remove fl ush glass door (see manual).
3. Carefully remove the logs from the packaging and unwrap them.
The logs are fragile, handle with care -never force into position.
4. Ensure glass crystals are installed on the burner.
HZ54E = 2lbs
HZ40E=1.5lbs
5. HZ54E only- Remove existing pilot hood - replace with pilot hood
provided with log set.
HZ54E - existing Pilot
Hood
919-258a
HZ54E/HZ40E - LOG INSTALLATION
1
2
3
6
7
HZ54E - new Pilot
Hood
6. Clip on log guides - position approximately 5" on either side of the
pilot hood.
7. Install Rear Log (1), by positioning cut out over pilot hood.
8. Push the rear log gently back, until it hits the log guides.
Log 1 in position
9. Place log placement template on the front fl oor of the unit.
Ensure L and R sides are in the correct position. Secure template in
place with magnets (supplied) on each side.
HZ40E - log placement template -
shown in place.
Regency Horizon™ HZ40E-10 Gas Fireplace
1
HZ54E/HZ40E
installation
|
Log guides
1
05/14/13
47
|
47
Advertisement
Table of Contents
