Optional Fan Installation - Initial Install - Regency Fireplace Products Horizon HZ40E-NG10 Owners And Installation Manual

Hide thumbs Also See for Horizon HZ40E-NG10:
Table of Contents

Advertisement

installation
|
40
120 Volt AC power is needed for the fan switch and blower. The fan can be
hard wired if desired. The receptacle box should be installed on the left
hand side of the unit by a qualifi ed electrician. The neutral (wider) slot of the
polarized receptacle should be at the top see manual for wiring diagram).
Unit must be grounded at all times. Do not cut the ground terminal off
under any circumstances.
Follow these instructions before the initial installation into the framing. If
installing the optional fan into an existing installation see the instructions on
the following pages.
1. Remove 8 screws to remove front access panel.
2) Slide the fan assembly through the front access panel - slide all the way
back to the back of the two tabs.
Installation Access Panel
2. Slide the fan through the front access opening – push the fan all the way to
the back until the fan base engages with the tabs on the bottom of the unit.
3) Secure the fan to the fl oor of the unit with 2 screws, in locations show
below.
919-405
40 |
Regency Horizon™ HZ40E-10 Gas Fireplace

OPTIONAL FAN INSTALLATION - INITIAL INSTALL

OPTIONAL FAN INSTALLATION
5. Connect one of the black wires from the power cord to the black wire
included with the fan (light blue connector). Connect the other end to one
spade on the thermodisc.
6. Connect the red wire to the other open spade on the thermodisc. Connect
the other end to the black wire from the fan motor.
7. Connect the white wire from the fan motor to the black wire on the power
cord (dark blue connector).
8. Slide the thermodisc on to the bracket clip on the bottom of the unit. Ensure
no wires will touch the hot surfaces.
9. Secure the ground wire from the fan assembly and the power cord to the
ground lug located on the back left near the fan.
10. The fan control module (supplied with the fan kit) secures to the side
access panel. Remove 2 top screws and loosen 2 bottom screws to
remove the side access pane
Tabs
1
HZ40E
06/26/14

Advertisement

Table of Contents
loading

This manual is also suitable for:

Horizon hz40e-lp10Horizon hz40e-ng1

Table of Contents