Connections - Panasonic WV-CS554 Operating Instructions Manual

CONNECTIONS

Precautions
• The following connections should be made by qualified service personnel or system installers in
accordance with NEC 725-51.
• Make sure to switch the camera off before installation or connection.
Note: When powered up, the unit performs a self-check (including one panning, tilting, zooming and
focusing operation).
• Power supply connection
Recommended wire gauge sizes for 24V AC line.
Copper wire size
(AWG)
Length
(m)
of Cable
(ft)
(Approx.)
Accessory Connector Information
Pin No.
1 24 V AC LIVE
2 24 V AC NEUTRAL
3 Ground
4 Not use
How to assemble the cable with the
accessory connector
Strip back the cable jacket approx. 3 mm (0.1
inch) and separate the individual conductors.
Approx.
3 mm (0.1 inch)
Up A
Up
Contact
Contact
51
24 V AC
Data Port
Video Output
The coaxial cable length (RG-59/U, BELDEN 9259) for the connection is up to
900 meters (3,000 ft.)
#24 #22 #20
(0.22mm 2 ) (0.33mm 2 ) (0.52mm
20 30 45
65 100 160
Power Source
4
2
Approx.
0.1 inch Wire
Wire
Insert
Insert the wire until A position
Insert the wire until A position
and clamp the contacts.
and clamp the contacts.
BNC Plug
Alarm In
Alarm Out
Prepare the individual conductors for clamping.
Use MOLEX band tool part number 57027-5000
#18
(for UL-Style Cable UL1015) or 57026-5000 (for
2 ) (0.83mm 2 )
UL-Style UL1007) for clamping the contacts.
75
After clamping the contacts, push them into the
260
proper holes in the accessory connector of this
camera until they snap in place.
3
1
CAUTIONS
• Shrinking the cable-entry seal is a one-
time procedure. Do not shrink the cable-
entry seal until it has been ascertained
that the unit is functioning.
CONNECT THIS TO 24V AC CLASS 2
POWER SUPPLY ONLY.
• To prevent fire or electric shock hazard,
the UL listed wire (VW-1, style 1007)
should be used for the cable for 24V AC
Input Terminals.
24 V AC Cable
RS485 cable
Coaxial Cable
To Video IN
(CAMERA IN)
BNC Plug
To Sensors
To Indicators
Up
Up
Contact Contact
Wire Wire