Panasonic WV-CS554 Operating Instructions Manual page 48

RS485 Setting
The 4-bit DIP switch in used for
RS485 termination and protocol
selection.
Switch
Position
BP 2
ON ON ON
Switch
Position
OFF OFF OFF
Notes:
• Defaults are marked with
• BP stands for Bit Position.
• Daisy chain connection is not available for
Full Duplex.
3. Assemble the camera
Reverse the disassembly procedure. Take
care not to cut any cables.
Precautions
Be sure to select a ceiling board strong
enough to support 4 times the total weight of
the camera.
a. Sideway cable exit
Prepare a cutout in the diecast case and
decoration cover as shown in the following
figures.
Cutout in Diecast Case
Cutout in Decoration Cover
49
4-bit DIP SW
ON
1 2
BP 1 Function
ON Termination ON
OFF Termination OFF
BP 3 BP 4 Function
Half Duplex (2 line)
Full Duplex (4 line)
.
*
Note: Remove sharp edges to protect the
cables.
3 4
*
b. Top cable exit
Prepare a hole in the ceiling board to run
the cables.
*
1. Mark the mounting holes on the ceiling,
using the removed camera mounting base
as a template.
2. Fix the camera mounting base to the ceiling
with four screws (not provided, M4).
Marking