Panasonic WV-CS554 Operating Instructions Manual page 15

3. Pan Offset
If the camera is replaced with a new one, Pan Offset is used to
adjust its positions to be the same as before.
Preset position data is uploaded by the controller that was once
downloaded before the former camera was removed.
Caution: The preset data for conventional protocol (WV-CS650
for example) is incompatible with WV-CS854's. WV-CS854's
preset data will be destroyed if you upload the conventional
data. When this happened, prepare a WV-CS854 having the
initial factory settings. Download the factory settings into the
controller and then upload to the camera whose data is
destroyed.
(1) Display the PRESET NUMBER SET menu.
(2) Select a position number for the picture to be most enlarged
among the numbers by moving the joystick. Then press the
CAM(SET) key. POSITION setting menu appears.
(3) Move the cursor to PAN OFFSET SET and select the left or
right arrow by moving the joystick.
(4) Press the CAM (SET) key until the desired offset value in
degree appears.
(5) Move the cursor to other than PAN OFFSET, then press the
MON (ESC) key.
Notes:
• Further adjustment of the other positions is unnecessary. This
adjustment applies to all other positions.
• Make sure to move the cursor before pressing the key in step
5. Otherwise the settings will be ignored.
• Retry when the camera fails to upload or download the data.
4. To set the lens zoom and focus positions
(1) Move the cursor to PUSH SET next to ZOOM/FOCUS and
press the CAM (SET) key. The ZOOM/FOCUS setting menu
appears.
(2) Select a zoom position by moving the zoom control up and
down, and a focus position by moving the focus control up
and down, and then press the CAM (SET) key.
The positions are set and the screen returns to the position
setting menu.
Note:
When the camera is used at a nearly horizontal angle, the
focus may not be adjustable to a high level of accuracy.
5. Move the cursor to RET and press the CAM (SET) key to return to
the preset setting menu.
Preset ID Setting
1. Move the cursor to PRESET ID on the preset setting menu and
select ON or OFF by moving the joystick to the left or right.
ON: Preset ID is displayed on the screen.
OFF: Preset ID is not displayed.
16
PRESET NUMBER SET menu
(1-32)
** PRESET NUMBER SET **
1* 2 3 4
5 6 7 8
9 10 11 12
13 14 15 16
17 18 19 20
21 22 23 24
25 26 27 28
29 30 31 32
ID:DOOR
33-64 RET
Position setting menu
** POSITION 1 **
→PUSH SET
PAN/TILT
→PUSH SET
ZOOM/FOCUS
PAN OFFSET SET ← −10.0 →
RET
FLOOR1
DOOR
Position setting menu
** POSITION 1 **
→PUSH SET
PAN/TILT
→PUSH SET
ZOOM/FOCUS
PAN OFFSET SET ← −10.0 →
RET
FLOOR1
DOOR
ZOOM/FOCUS setting menu
** POSITION 1 **
→PUSH SET
PAN/TILT
→PUSH SET
ZOOM/FOCUS
U ZOOM D/L FOCUS R
RET
FLOOR1
DOOR
Position setting menu
** POSITION 1 **
→PUSH SET
PAN/TILT
→PUSH SET
ZOOM/FOCUS
PAN OFFSET SET ← −10.0 →
RET
FLOOR1
DOOR
Preset setting menu
PRESET NO. 1*
POSITION SET
PRESET ID ON
ALC/MANUAL ALC
DWELL TIME 10S
SCENE FILE OFF
PRESET SPEED ••••|••••
L
RET DEL
H