Panasonic WV-CS554 Operating Instructions Manual page 38

9. Motion Detector Setting (MOTION DET)
1. Display SET UP on the monitor screen.
(Refer to Setup Menu Display on page 14 for details on display-
ing the SET UP menu on the monitor screen.)
2. Move the cursor to MOTION DET and select ON or OFF by using
the joystick. Then press the CAM (SET) key when you select ON.
3. When you select ON, the motion detect setup menu appears.
You can mask the areas in this menu.
4. Move the cursor to MASK SET and press the CAM (SET) key.
48 mask areas appear on the monitor screen.
Refer to the Light Control Setting section on page 33 for masking
operations.
5. After masking areas, press the MON (ESC) key. The motion
detect setup menu appear on the monitor screen.
6. Move the cursor to ALARM and select ON or OFF by using the
joystick.
ON: The alarm signal is supplied while the DISPLAY MODE is
active.
OFF: The alarm signal is not supplied while the DISPLAY MODE
is active.
7. Move the cursor to DISPLAY MODE.
Press the CAM (SET) key to see the present setting. The areas
that detect the motions start blinking.
8. Move the cursor to LEVEL by using the joystick.
Use the joystick to obtain the optimum detection level. The "I"
cursor moves to the left or right.
Note: Repeat the above procedures until you obtain the desired
adjustment.
9. Move the cursor to RECOVER TIME by using the joystick.
You can select the recover time for from the following values:
OFF
60MIN
10. Move the cursor to RET and press the CAM (SET) key to return to
SET UP.
39
1MIN 2MIN 3MIN
30MIN 20MIN 10MIN
5MIN
Camera setting menu
** SET UP **
CAMERA ID OFF
ALC/MANUAL ALC
SHUTTER ---
AGC ON
SENS UP OFF
SYNC INT
WHITE BAL ATW
MOTION DET ON
AF MODE MANUAL S
RET SPECIAL2
Motion detect menu
** MOTION DETECT **
LEVEL ••••|••••
- +
DISPLAY MODE
ALARM OFF
MASK SET
RECOVER TIME 1MIN
RET