Install The Safety Barrier; Install The Mesh And Grille - Vermont Castings RADVT(CS)CBSB Installation And Operating Instructions Manual

Radiance Direct Vent Gas Heater
®

Install the Safety Barrier

S
AFETY
NOTE: A barrier designed to reduce the risk of burns
from the hot viewing glass is provided with this
appliance and shall be installed for the protection of
children and other at risk individuals. If the barrier
becomes damaged, the barrier shall be replaced with
the manufacturer's barrier for this appliance.* Any
safety screen, guard, or barrier removed for servicing
the appliance must be replaced prior to operating the
appliance.
* See parts list for model number.
The safety barrier has been designed to work with the
doors open or closed.
1. Remove screen from packaging.
2. Place the two bottom hooks over the bottom edge of
the stove opening Figure 55
3. Press the screen against the stove snapping the two
spring fingers until the screen fits securely in place.
NOTICE: It is the responsibility of the installer to ensure
the barrier is affixed to the fireplace at the time of instal-
lation.
DANGER
A barrier designed to reduce the risk of burns from
the hot viewing glass is provided with this
appliance and shall be installed.
DANGER
3030
CERTIFIED
B
ARRIER
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
Un panneau vitré chaud peut
causer des brûlures.
Laissez refroidir le panneau
vitré avant d'y toucher.
Ne laisser jamais les enfants
toucher le panneau vitré.
Bottom
Hooks
Fig. 55 Install safety barrier screen.
WARNING: The safety screen barrier
must be installed after the glass front is
in place. It is NOT a replacement for the
glass and the unit must NOT be oper-
ated without the glass in place.

Install the Mesh and Grille

Place the mesh and grille on the top of the Radiance stove
to complete assembly.
20306759