Vermont Castings RADVT(CS)CBSB Installation And Operating Instructions Manual page 27

CAUTION: Before installation, inspect ember
bed burner for damage. Do not use ember
bed if damaged or cracked. NOTE: Small,
shallow surface cracks are acceptable.
1. Remove the logs from their packaging and
inspect each piece for damage. DO NOT
INSTALL DAMAGED LOGS.
2. Install the rear log by placing it on the
ember bed toward the back of the firebox.
(Fig. 48) The log should touch the back
wall of the firebox. When the log is in place,
the two (2) notches on the bottom of the log
rest on the two (2) ribs on the back side of
the ember bed. (Fig. 49)
Figure 49
3. Install the front left and right logs
(Fig. 50) by placing them on the
ribs shown in Figure 49. Make
sure the logs line up with the flat
spots on the ember bed intended
for location purposes. (Fig. 49)
4. Install the left cross log by engag-
ing the hole on the bottom with the
pin on the left side of the rear log.
Set front side of cross log on notch
in ember bed. (Fig. 51)
5. Install the right cross log by engag-
ing the hole on the bottom with the
pin on the right side of the rear log.
Set front edge of cross log on em-
ber bed as shown in Figure 51.
20306759
Figure 48
Ribs for Rear Log
Rib Flat Spot for
Front Left Log
LG487
Figure 50
ember bed
6/07
Radiance
LG488
rear log
Ember Bed
6/07
Rib and Flat Spot
for Front Right Log
Front Left Log
LG489
front logs
6/07
Direct Vent Gas Heater
®
Rear Log
LG488
LG487
Front Right Log
LG489
27