Table of Contents
Advertisement
Unpack the Stove:
The stove is shipped fully assembled on its back. Unpack
the stove and carefully set it upright.
!
Porcelain enamelled surfaces are fragile. Handle porcelain
enamelled castings tenderly. Familiarize yourself with
the assembly steps before you begin and proceed
with deliberation and care. If possible, have assistance
available.
Place enamelled castings on a soft, cushioned surface
until you are ready to assemble.
Avoid contact between the castings and other hard
surfaces or objects.
NOTE: Verify the two relief doors (located on top of the
firebox) are properly seated on the gasket. The doors sit
flush on the gasket, and should lift easily from the seal
around the opening.
If you are installing the fan, install it before completing
the stove venting.
If you are not installing a fan, proceed to the appropriate
vent assembly section.
Install Optional Fan Kit FK20
Fan Kit Contents:
• #10 x 1/2" phillips screws, 2
• Control Knob
• Retaining Nut
• Snapstat Bracket
• Blower Assembly w/ Rheostat Control & Snapstat
1. Remove the rear fan cover by removing the four (4) screws
holding the cover in place on the rear shroud. (Figure 13)
Retain the screws for future use.
2. Attach the Snapstat to the bracket using two (2) #10 x
1/2" Phillips screws. (Figure 14)
3. Locate and remove the 1/4-20 x 3/8" hex head bolt
installed in the hole in the right rear ledge of the firebox.
(A, Figure 14) Use that bolt to secure the snapstat bracket
to the firebox. The mounting hole is slotted to allow you
to adjust the bracket so the snapstat head makes contact
with the firebox surface. (Figure 14)
4. Attach the fan to the firebox by reusing the two (2) pan
head 1/4-20 screws on the top edge and the two (2) #10
x 1/2" sheet metal screws on the side edges. (Figure 15)
5. The rheostat control switch attaches to the control panel
plate provided on the front of the stove.
13
Installation
CAUTION
• Wire Tie
• Snapstat
Remove Four
(4) Screws
(Retain for
future use)
Figure 13 - Remove four (4) screws holding rear fan cover in
place. Retain for future use.
1/4-20 x 3/8'
Phillips Screw
1/2" Sheet
Metal
Screw
Snapstat
Figure 14 - Attach snapstat.
Upper
Flange
#10 x 1/2"
Sheet Metal
Screw
1/4-20 x 3/8"
Screws (2)
#10 x 1/2" Sheet
Metal Screw
Figure 15 - Use screws removed earlier to attach fan kit to firebox.
•
Insert the switch box shaft through the hole in the back of
the left side of the panel, aligning the locator pin with the
smaller hole in the panel. (Figure 17)
•
Attach the retaining nut to the switch control shaft to secure
it to the plate.
•
Attach the control knob to the rheostat shaft.
KT899
FK30 remove cover
6/07
A
Snapstat Bracket
KT900
attach snapstat
7/07
To Control
Valve
20012761
Advertisement
Table of Contents
