Instructions For Rcsitea - Vermont Castings RADVT(CS)CBSB Installation And Operating Instructions Manual

Radiance Direct Vent Gas Heater
®

Instructions for RCSITEA

RADVTCS Series
CAUTION: The RCSITEA is only certified for use on vent-
ed heater rated equipment.
This remote control system provides a safe, reliable and
user-friendly remote control for millivolt valve gas appli-
ances, blower speed and flame height adjustment. The
system can be manually or thermostatically turned on and
off with the transmitter.
Carefully inspect the contents for shipping damage. If any
parts are missing or damaged, immediately contact your
dealer. Do not attempt to install any part of the kit unless
all parts are in good condition. Refer to instructions pro-
vided with the kit for complete installation instructions.
WARNING: Make sure 120V AC fan and SIT valve are
correct. If not wired correctly, damage to receiver could
result. Make sure the wires do not contact the appliances
any place other than at the terminals. Exposure to tem-
peratures higher than 250°F (105°C) may cause the re-
ceiver to malfunction and cause possible fire hazard.
3434
Remote Transmitter
Install Batteries
The remote transmitter uses three (3) "AAA" batteries.
1. Press down the battery door tab and pull out to remove
the battery door. (Fig. 59)
2. Install the batteries as indicated on transmitter.
3. Close the battery door by snapping in place.
4. When three (3) batteries are installed, the transmitter
will initialize for 10 seconds and then is ready for use.
5. The batteries should be replaced at least once every
six (6) months or when the low battery indicator is dis-
played.
Setting Privacy (DIP) Switch on Receiver and Trans-
mitter
The remote receiver and transmitter privacy (DIP) switch-
es are preset at the factory. In the event of activation or
interference from other nearby transmissions, reset the
code using the following procedure:
1. Slide the code switches on the transmitter and receiver
to choice of ON or OFF position. Switches #1, #2, #3
and #4 are preset to "ON" for both the transmitter and
receiver. (Fig. 60)
2. The switches on the transmitter and receiver must
match in order for the system to work.
Battery
Door
Tab
Fig. 59 Battery door tab.
ST1088
RCSITE battery tab
20306759