Important Information; Replacement Parts; Gaskets, Oil Seals And O-Rings - E-TON EV3 E-MO Service Manual

IMPORTANT INFORMATION

or
IMPORTANT INFORMATION

REPLACEMENT PARTS

1. Use only genuine E-TON parts for all
replacements. Use the oil and/or grease
recommended by E-TON for assembly
and adjustment.

GASKETS, OIL SEALS AND O-RINGS

1. Replace all gaskets, seals and O-rings
when overhauling the rim. All gasket surfaces,
oil seal lips and O-rings must be cleaned.
2. Properly oil all mating parts and bearings
during reassembly. Apply grease to the oil
seal lips.
LOCK WASHERS/PLATES AND COTTER
PINS
1. Replace all lock washers/plates
ter pins after removal. Bend lock tabs along
the bolt or nut flats after the bolt or nut has
been tightened to specification.
BEARINGS AND OIL SEALS
1. Install the bearings
their manufacturer brands or numbers facing
outwards. (In other words, the stamped letters
should be on the side exposed to view.) When
installing oil seals, apply a light coating of
lightweight lithium base grease to the seal
lips. Put oil on the bearings when installing.
NOTICE
Do not use compressed air to spin the bea-
rings dry. This will damage the bearing surfa-
ce.
1-2
GEN
INFO
and cot-
and oil seals with