Status - E-TON EV3 E-MO Service Manual

DRIVER

STATUS

Status: Unable to starting computer booting (there
is no display on the panel instrument or beep
tone continues).
• Operate according the testing interface operation
steps. If the illustration in the left still doesn't
appear, the driver shall be replaced.
Status: If electricity shuts down during riding (the
power and instrument panel display disappear)
• Operate according the testing interface operation
steps. If the system report like in illustration
in the left still doesn't appear, the driver shall
be replaced.
• If the system report appears, connect the
instrument panel connector with the driver and
start the booting. After successful booting, turn
the rear wheel slowly. If the electricity shuts
down, the driver shall be replaced.
Status: Operate the throttle switch after the booting
but the vehicle doesn't respond.
• Operate according the testing interface operation
steps. After the system report status appear,
turn the handle throttle. The turn range is bigger
as the digits in the selected frame become
bigger. If the digits don't change as the throttle
switches on or off, the driver shall be replaced.
Status: The vehicle can't run smoothly and suffers.
• Operate according the testing interface operation
steps. After the system report status appear,
turn the rear wheel slowly. The selected frame
will also change. If the selected frame doesn't
change as the rear wheel turns, it means
unchanged or the change doesn't proceed as
in the sequence in the following list, the driver
shall be replaced.
Hall logic list
U-Phase Hall
Order
Voltage
4-10
CONT
V-Phase Hall W-Phase Hall
Voltage Voltage