Charger; Installation Steps - E-TON EV3 E-MO Service Manual

CHARGER

Power switch Electricity voltage switch
230
Charging outlet
LED
+V -V
Input terminal
Battery
Charger
Power switch
Terminal
Charger
Power cable
Charging outlet
Charging plug
Power outlet

INSTALLATION STEPS

1. Make sure the charger is switched off. Connect
the battery to output terminal. Select proper
output wire suitable for the electricity current to
act as the conducting wire between the battery
and charger.
WARNING
Each pole shall be connected correctly. Pos-
itive pole (+) shall be connected to (+) terminal
and negative pole (-) shall be connected to (-)
terminal. Output positive and negative poles
shall avoid short circuit.
2. Use selection switch to adjust the AC input
electricity voltage range 115/230V according
to local electricity voltage. Factory default is
preset to be 115V(Taiwan).
3. After the electricity power is connected, turn
the power switch (0/-) to ON(-). Check whether
the LED light illuminates in red (in charging
status). Green light indicates it is already fully
charged.
N O T I C E
This battery can charge for the lithium battery
of this vehicle.
This charger shall be kept in drafty and dry
and shall avoid exposure to rain or snow.
The length of conducting wire connecting
the battery to the charger shall be kept as
short as possible to avoid lengthening the
time for full charge due to excessive vol-
tage reduction.
Make sure the charging electricity voltage
and electricity current complying with battery
specification.
Both new and old battery can't be charged
in parallel connection.
Make sure the charger is switched off upon
plugging into or off the conducting wire.
2-year warranty is provided for the charger
except damage caused by improper usage.
5-4
BAT
– +
CHA