E-TON EV3 E-MO Service Manual page 101

Code
SPD0 Operate code lock during riding.
Over speed warning.
FAST
(over 52KM/HR)
LOWB
Low battery.
Using Power mode during low battery residual
LOWP
charge.
1. This message will display to remind the
rider that vehicle locking has already been
set success fully.
LOCK
2.This message will display on restarting to
remind that the vehicle locking has already
been set success fully.
FAIL
Wrong password.
Indication
On setting vehicle locking password, this
message will display to remind the rider to
OLD
input old password if an old password has
already existed.
ON setting vehicle locking password, this
message will display to remind the rider to
NEW
input a new password if there are no password
was set up in system or already enter the
correct password.
During standby mode, this message will dis-
PUSH
play to remind the user to press confirmation
button to enter into riding page.
After starting. This message will display to
remind the rider if the vehicle still stays in
PRES
standby page but the rider intends to turn around
handlebars.
After PRESS is conducted, this message
will display to remind the rider if the confirmation
TPS0
button is pressed before handle bar is not
yet released.
Cause
No operating code lock during riding can terminate this message.
Reducing driving speed as soon as possible.
Recharge battery as soon as possible.
The system will shift back to standard mode automatically and LOWP
will disappear.
1. Rider can switch off safely.
2. Press confirmation button and input password to unlock the vehicle.
Re-enter the password.
Enter the old password.
Enter the new password.
Press confirmation button A.
Release throttle handle and press confirmation button to enter into
riding page.
Release throttle handle and press confirmation button to enter into
riding page.
Action
8-4
TRBL
SHTG