E-TON EV3 E-MO Service Manual page 37

MOTOR
1
3
2
• Remove brake cable adjusting bolt
• Remove brake cable set nut
• Adjust the adjusting nut
and fix the groove
• Remove brake cable.
1
• Loosen set nuts on left and right motor and
frame as illustrated.
1
• Remove motor three-phase circuit
2
connector
• Pull the three-phase circuit and Hall connector
across frame gap.
• Remove the motor.
WARNING
1
When failed, the precise circuits and electronic
component in the motor must be replaced or
repaired by the authorized dealer immediately
and are forbidden to be removed and decomposed
by the rider to insure riding safety.
4-3
CONT
to rear end.
1
2 to loosening position
across the brake drum.
3
as illustrated.
2
.
1
and Hall
1