Checking The Froent Fork - E-TON EV3 E-MO Service Manual

CHECKING THE STEERING HEAD/
CHECKING THE FRONT FORK
d. Loosen the lower ring nut 1/2 turn counter-
clockwise then tighten it to specification with
a steering nut wrench.
Lower ring nut (final tightening torque)
12 Nm (1.2 m • kg, 8.7 ft • lb)
e. Check the steering head for looseness or bind-
ing by turning the front fork all the way in both
directions. If any binding is felt, remove the
front fork and check the upper and lower bearing.
Refer to "STEERING HEAD" in chapter 7.
f. Hold the lower ring nuts with a ring nut wrench
and tighten the upper ring nut with a steering
nut wrench.
Upper ring nut
50 Nm (5.0 m • kg, 36.2 ft • lb)
6. Install
• Side cover (R)
• Headlight
• Side cover (L)
• Meter
• Front cap
CHECKING THE FRONT FORK
1. Stand the scooter on a level surface.
2. Check
• Front fork
3. Operation
Push down hard on the handlebar several
times and check if the front fork rebounds
smoothly.
Rough movement
Refer to "FROENT FORK" in chapter 7.
WARNING
• Securely support the scooter so that there
is no danger of it falling over.
• If there is any abnormal sound, please
replace immediately.
3-9
CHK
ADJ
Replace