Intermec CK30 Service Manual page 85

Supported Scanners
Device
EV10 1D imager
E1022/E1025
EL10 Micro-Mirror Laser
SE900
SE900HS
SE1200
SE1200ALR
I2 and IT4000 2D imagers
Tethered undecoded scanners:
1550C01xx
128x wands
Tethered decoded scanners:
1400
1551E
1553
1800 ScanPlus
Tethered decoded scanners:
1400
1551E
1553
1555
1470B
1800 ScanPlus
DBP = Legacy laser scanner interface, using DBP, SOS, LAS_EN, and SCAN_EN signals.
MDS = High-speed serial SPI interface developed by Toulouse for transferring raw A/D data to the host processor.
RSTTL = TTL-level RS-232 from a scanner with built-in decode.
Wand-em = Wand emulation mode using only the DBP signal; used by scanners with built-in decode.
CK30 Handheld Computer Service Manual
Interface Type
DBP
MDS
DBP
Decoded RSTTL
DBP
DBP
DBP
DBP
DBP
8-bit parallel pixel data
DBP
Wand-emulation
Decoded RSTTL
The CK30 platform uses the main processor to decode bar code
information from undecoded 1D laser, 1D CCD- and CMOS-based
imagers, and 2D imager input devices. The interface also supports serial-
output decoded scanners.
Chapter 4 — Theory of Operation
Support Status
Supported in SE900 compatibility mode.
MDS mode to be added in a future release.
Supported in architecture, but not implemented.
Supported in architecture, but not implemented.
Supported, but not released as a valid
configuration.
This is implemented, but not released as a valid
configuration.
This is implemented, but not released as a valid
configuration.
Supported.
Supported.
Supported.
Supported.
Supported.
Supported, but not released as a valid
configuration.
Supported in a future release.
Supported.
Supported.
Supported in a future release.
Supported in a future release.
Supported in a future release.
75