Replacing The Bluetooth Radio - Intermec CK30 Service Manual

Replacing the Bluetooth Radio

CK30 Handheld Computer Service Manual
6 Replace the mini PCI shield assembly by threading the Ethernet cable
through the opening in the shield and replacing the four Phillips screws.
7 Connect the Ethernet cable to J12 on the main PCB.
8 Close the CK30. For help, see "Closing the CK30" on page 27.
To replace the Bluetooth radio, you need the following tools and parts:
• T10 Torx screwdriver
• Small Phillips screwdriver
• Bluetooth radio (P/N 855-050-001)
• Phillips 4-40 x .875 screw (P/N 590939-001)
• Elco screw (591825-001)
To replace the Bluetooth radio
1 Open the CK30. For help, see "Opening the CK30" on page 9.
2 Disconnect the power/good read indicator light pipe assembly cable
and the speaker PCB assembly cable from the main PCB.
Power/good
read indicator
light pipe
assembly
cable
3 Remove the two Phillips screws with captive washers from the top of the
main PCB and gently separate the main PCB from the top cover as
shown in the next illustration.
4 Detach the display flex cable and the keypad flex cable from the main
PCB.
5 From the backside of the main PCB, remove the Phillips screw that
attaches the Bluetooth radio retaining clip and pull it away from the
main PCB.
Chapter 2 — Replacing Parts
Speaker
PCB assembly
cable
13