Intermec CK30 Service Manual page 21

CK30 Handheld Computer Service Manual
Mini PCI
shield
assembly
Mini PCI
radio
assembly
4 Use the antenna cable remover tool to carefully lift the antenna off of
the mini PCI radio assembly. Insert the prongs under the antenna cable
socket and lift gently.
Note: Do not pull on the wire because the cable will break. If you do
not have an antenna cable remover, insert your fingernails under the
antenna cable socket and lift gently.
5 Open the radio card retainer clips and pull the mini PCI radio assembly
away from the connector.
6 Insert the new mini PCI radio assembly into the connector until it
cannot go in any further and then push it down until the radio retainer
clips lock in place.
7 Attach your new antenna cable to the mini PCI radio assembly.
8 Replace the mini PCI shield assembly.
9 Replace the antenna ground plane and antenna.
10 Close the CK30. For help, see "Closing the CK30" on page 27.
Screw
(2 places)
Antenna
Screw
(2 places)
Screw
(2 places)
Bottom
cover
Retainer
clips
Chapter 2 — Replacing Parts
Antenna
ground
plane
11