Pd Base Plate/10 Pin Terminal - Nikon D300 Repair Manual

PD base plate/10 pin terminal

・Assemble the 10-pin terminal (#41) as below, and tighten the screw (#65).
・Attach the 1��pin ��PC (#1�1�) by fitting with the bosses.
・ Put the lens�release SW lug plate (#�8�) by fitting in the screw hole of �#1�1��, and tighten the screw (#15�3).
・Make the solder to joint the 10-pin terminal and the �PC (at nine places), and solder the wire (#1119) of the
lens-release SW on the lug plate (#680).
・Connect the �PC (#1042) to the connector of the PD base plate (#1002).
・Then mount the PD base plate (#1002) on the front body, and tighten two screws.
・Connect the 10-pin �PC (#1010) to the connector of [#1002].
・Solder the ten wires as below.
Black: Lens contact �PC
Red: Lens contact �PC
PD base plate: #1002
Adhesive: Loctite
10-pin �PC (#1010)
10-pin terminal (#41)
Soldler at 9 places
・
Blue: Lens release SW
Black: 10-pin �PC
Red: 10-pin �PC
#65
- Ａ  ・
Red: SCM-change base plate
Brown: SCM-change base plate
Black: SCM-change base plate
#B1034
#1503
#1119:Black
Lens-release SW
lug plate (#680)
#1522
-
logo Q0310 forGraphic
070509 Gdesign ito
INC
VBA20001-R.3720.A
Yellow / Black: A� motor
#1042
#1522