Height adjustment of A� coupling shaft
・Set the position of the focus mode select dial to "C".
・Adjust the height of the coupling shaft (#342) to become "1.7±0.2 mm" by using the screw (#359).
※ ※ When the focus mode is set to "S", [#342] does not move.
※ ※ When the focus mode is set to "M", [#342] must not protrude from the bayonet face.
※ ※ When the release-button is fully pressed, [#342] must not
protrude from the bayonet face
・��i� the screw (#35�) with the adhesive.
Height adjustment of Aperture lever
・Measure the height of the aperture lever by using the tool (J18004).
Standard: 3.4 - 3.45mm
Be careful �OT to bend the lever during adjustment.
・If the result is out of standard, make the adjustment by using the
adjustment screw.
3.4 ~ 3.45mm
Aperture lever
Adhesive: Screwlock 1401C
- A ・
-
logo Q0310 forGraphic
070509 Gdesign ito
INC
VBA20001-R.3720.A
1.7±0.2mm
Bayonet
#342
#359
,
Adjustment screw
Adhesive: Screwlock