Start Adjustments; Shooting Condition; How To Confirm - Nikon D300 Repair Manual

8. Procedure
8-1. Shooting image adjustment
● Calculate the "Sensitivity" and "Sensitivity ratio" reference values by using D3�� reference body
beforehand, then perform the adjustments. (ref. 9-4.)
● ��or shooting image adjustment, make all items from (1) to (7). The adjustments from (1) through (7) are
all programmed to be e�ecuted in serial order. When 1 item is completed, the software automatically goes
on to the ne�t adjustment.
● �n case adjustments are interrupted by NG, the adjustments can be continued again after NG. As for
adjustments that were ended with OK, the flash memory updates of the adjustment value are completed.
�ote: Adjustments are not possible without resetting "Custom setting" of this camera.
Before the adjustments, record the details of "Custom setting" set by customers if necessary.

Start adjustments

・Provide the power for the camera via AC adapter.
・Reset "Custom setting".
・Set "PTP" mode by Setup menu.
・Set the focus mode to "M", e�posure mode to "M", and the e�posure compensation to "�" of the camera.
・Connect the camera and PC via USB cable.
・Set the luminance of the color viewer to LV13 equivalent.
・Set the shutter tester to LV9.
(1) Gr�Gb difference compensation adjustment (G filter)
● Writing of the image sensor unique data
Based on the procedure of the image adjustment software,
with two-dimensional barcode reader and write the image sensor-unique data into the DG-PCB.
※ Set the settings of the two-dimensional barcode reader. (ref. Page A53)
※ �E��ORE assembly, take a picture, with a digital camera, of the QR code that is attached to the ��PC of the
image sensor holder unit.
・When the image sensor holder unit is replaced, or the DG-PCB unit and the image sensor holder unit are
replaced, take a picture of the QR code of the image sensor of RP.
・When the DG-PCB unit is replaced, take a picture of the QR code of the image sensor holder unit that is
attached to the body.
【Shooting condition】
Compact digital camera is used:
・Quality:
・Size:
・Shooting mode:BSS
・A� mode:
・SB mode:

【How to confirm】

＊ Perform "QrReader (J�5���)".
code on the playback screen can be read out with two-dimensional barcode reader.
���NE
3M
Closeup mode
�lash cancel
Play back the image of the shot QR code, and confirm that reading of the QR
- Ａ  ・
read the shot QR code on the playbacked screen
-
logo Q0310 forGraphic
070509 Gdesign ito
INC
VBA20001-R.3720.A
QR code