DG-PCB
・Remove the harnesses (#1075, #1074, and #1073) from each connector.
・Disconnect the FPC (#1027
#1027、#1040、#1041、#1039、#1038) from each connector.
・Take out the screw (#1546) and remove [#B1017].
#1041
#1075
#1073
#1040
CF base plate unit
・Take out the three screws (#1543) and remove the CF base plate (#1018).
#1543×3
Image sensor holder unit
・Unsolder the DR base plate (#1014) at four places.
・Take out the three screws (#1639) and remove the
image sensor holder unit (#B10521).
DR base plate
Red
Black
Gray
Orange
- D ・
) from each connector.
#1039
#1074
#1027
#1038
#B1017
#1038
-
logo Q0310 forGraphic
070509 Gdesign ito
INC
VBA20001-R.3720.A
#1546
#1018
#1014
#B10521
#1639×3