Installment Of P.box Unit - Nikon D300 Repair Manual

AE �PC unit
1. Assembly
・Put three AE adjustment springs (#884) on
[#B882].
・Mount the AE block (#B1006) on [#B882].
※ ※ Mount by fitting the AE adjustment
springs with concave portions of the AE
block.
※ ※ Be careful that the springs (#884) do not
run off the edge from the areas that joint
with [#B1006].
・Turn three screws (#883) to attach [#B1006]
to [#B882] temporarily.
※ ※ Give the screws light turns.
・Then, give the three screws (#883) one and
half turn counterclockwise.
2. Installment
・Mount the AE �PC unit on [#831].
・Tighten three screws (#1617).
・�old the �PC (#1006) and connect to the connector of the �PC (#1005).
・Hook the top edge of the �PC (#1006) to the hole of [#1054].
�nstallment of P. �o� unit
・Assemble the P. �o� unit into the body, and tighten four screws (#1�12).
・ Connect the penta-�PC (#1005) to the connector of PD base plate (#1002).
・ Connect the lens contact �PC unit (#B1008) to the connector of the penta-�PC
(#1005).
�PC #1005
Lens-contact �PC unit (#1008)
PD base plate #1002
- Ａ  ・
AE block
(#B1006)
#884×3
#B882
#1617×3
#1054
#1006
Outward fold
#831
-
logo Q0310 forGraphic
070509 Gdesign ito
INC
VBA20001-R.3720.A
#883×3
#1006
山折り
#1005
#1612×4