Image Shutter Adjustment; Pixel Defect Compensation-Black Point; Pixel Defect Compensation-White Point - Nikon D300 Repair Manual

（7）Image shutter adjustment
・Click "�. �MAGE SHUTTER �NS. & ADJ." of the main menu on screen.
・Attach the tool lens (Aperture �5.6) to the camera.
・Get the camera closest to the center of the illuminated surface of the shutter tester.
・ Make inspection and adjustment with the luminance LV9 and LV15.
・ Confirm that the inspection is within standard.
8-2. Pixel defect compensation - black point
・Set the color viewer luminance to LV13 equiv.
・Provide the power for the camera via AC adapter.
・Reset "Custom setting".
・Set "PTP" mode by Setup menu.
・Set the focus mode to "M", e�posure mode to "M", and the e�posure compensation to "�" of the camera.
・Connect the camera and PC via USB cable.
・Click "BLACK POI�T" of "PIXEL DE�ECT COMPE�SATIO�" of the menu.
・Attach the tool lens (Aperture ��5.�) to the camera (without filter).
・Get the camera closest to the center of the illuminated surface of the color viewer.
・When the adjustment starts, pi�el defects are detected, displaying the number of pi�els and addresses.
・After confirming the above, click "X" button.
・When it is completed, "OK" is displayed.
・The software automatically goes on to the ne�t "WH�TE PO�NT" of "P�XEL DE��ECT COMPENSAT�ON".
(After the black point compensation, be sure to perform the white point compensation, too.)
�ote: In some cases, �G occurs due to dusts on the OPL�.
Be sure to clean the OPL� surface before adjustments.
8-3. Pixel defect compensation - white point
・Check the environmental temperature (appro�. 2��25°C.).
・Provide the power for the camera via AC adapter.
・Reset "Custom setting".
・Set "PTP" mode by Setup menu.
・Set the focus mode to "M", e�posure mode to "M", and the e�posure compensation to "�" of the camera.
・Connect the camera and PC via USB cable.
・Click "WHITE POI�T" of "PIXEL DE�ECT COMPE�SATIO�" of the menu.
・Cap the camera with the body cap or lens cap to shield light from the mount.
・When the adjustment starts, pi�el defects are detected, displaying the number of pi�els and addresses.
・After confirming the above, click "X" button.
・When it is completed, "OK" is displayed.
- Ａ  ・ -
logo Q0310 forGraphic
070509 Gdesign ito
INC
VBA20001-R.3720.A