Toyota Automobile Electrical Repair And Modification page 69

TERMINAL AND CONNECTOR REPAIR–HOW TO INSTALL AND REMOVE SPECIAL CONNECTORS
Coil spring
Pin
Convex part
Lock
Double
locking
device pin
1.
Primary locking
device
2.
Lock
3.
Wire Harness Repair Manual (RM1022E)
The connector with secondary locking
device
Area used
D Wire harness for SRS airbag deployment
Cut the connection of the connector.
(1) Release the double locking.
(2) Release the primary locking and separate the
connector.
NOTICE:
Do not hold the wire harness to pull it.
Connect the connector
(1) Install the primary locking device and connect the
connector.
(2) Install the double locking device.
NOTICE:
The double locking device can not be installed unless
the primary locking device is installed.
B–51
67