Toyota Automobile Electrical Repair And Modification page 53

TERMINAL AND CONNECTOR REPAIR–TERMINAL REPLACEMENT
Three or More Times
10 mm (0.39 in.)
Tape overlapping
10 mm (0.39 in.)
Two or More Times
Finish
HINT:
D Before starting the operation, thoroughly wipe dirt and
grease off the sections to be joined.
D If the adhesive surfaces of two tapes come in contact
they will stick together and will not come apart, so do
not remove the backing film except when using the
tape.
D Do not let oil and dust, etc. get on the tape surface.
(a) Ready about 100 mm (3.94 in.) of silicon tape (Part
No. 08231–00045) and peel off the film.
(b) Stretch the silicon tape until its width is reduced by
half.
(c) About 10 mm (0.39 in.) from the end of the sleeve,
wrap the silicon tape around the sleeve three or more
times while stretching the tape.
(d) Wrap the remaining part of the sleeve with half of the
tape overlapping at each turn.
(e) Firmly wrap the tape two times or more about 10 mm
(0.39 in.) from the other end of the sleeve, then wrap
the tape back towards the start again and firmly finish
winding the tape around the center of the sleeve.
Wire Harness Repair Manual (RM1022E)
B–35
51