B–18
TERMINAL AND CONNECTOR REPAIR–TERMINAL REPLACEMENT
Service hole
Retainer
Special tool
34
Type F (For C–Type Connector)
(1)
(2)
HINT:
of the thin arrow shown in the illustration.
(3)
Type G
D Insert the special tool into the position shown in the
Lock
Wire Harness Repair Manual (RM1022E)
Insert the special tool into the service hole.
Move the special tool to the direction of the arrow and
release the lock.
Lift the retainer up after moving it to the direction
Pull the retainer forward by hand and remove the
retainer from the housing.
illustration. Pry it to the direction of the arrow and
push the lock up to release it.