Toyota Automobile Electrical Repair And Modification page 59

TERMINAL AND CONNECTOR REPAIR–TERMINAL REPLACEMENT
Bad Example:
Terminal in Short
Position
[Case 1]
Full Lock Position
[Case 2]
Full Lock
Position
(b)
HINT:
1.
2.
NOTE: If the terminal to locking clip does not lock firmly,
terminal retainer can not lock at full lock position so the
terminal backs out from connector.
Terminal
Locking
Clip
(c)
Wire Harness Repair Manual (RM1022E)
Insert the terminal until the locking clip locks firmly.
Pull the terminal back gently to check whether it is
locked correctly.
If it cannot be inserted easily, check the terminal and
the connector for damage.
"For Case 1"
Push the terminal retainer in to the full lock position.
"For Case 2"
Raise the terminal retainer up to the full lock position.
B–41
57