TERMINAL AND CONNECTOR REPAIR–TERMINAL REPLACEMENT
Special Tool
Access Hole
Tab
Open
∗
∗
[Male]
Retainer
Side Lock
Type B (For 1.8, 1.0 and TLC of Non–Waterproof Type
Connector)
(1)
Press the special tool at a 45° angle into the locking
lug access hole as shown.
Raise the double locking device up as far as possible.
(2)
Remove the special tool and open the double locking
device
NOTICE:
TLC housing is not be reusable. Please replace it with
the new one after replacement of the terminal.
∗ Double Locking Device.
Type C (For TNS, FTC Type Connector)
(1)
Widen the side lock part of the retainer from side to
side using the special tool.
Wire Harness Repair Manual (RM1022E)
∗
Open
∗
[Female]
B–11
27