Toyota Automobile Electrical Repair And Modification page 44

B–26
TERMINAL AND CONNECTOR REPAIR–TERMINAL REPLACEMENT
"Non–Waterproof Type"
Locking Clip Terminal Retainer
0.64 Type
Stopper Portion
Tool Hole SST
Terminal Lance
Non–waterproof type TLC housing
Insert the tool from wire harness side
42
(f) Insert the SST into the connector in the direction
shown in the chart.
(g) Insert the SST fully to the tool hole, and push the
terminal lance.
NOTICE:
D The terminal has a lance shape, therefore, the
housing may be damaged and the terminal may get
stuck if forcibly pried by wires etc.
D Insert the SST so that the stopper portion surface is
facing up.
(h) Carefully withdraw the terminal from the connector by
pulling the lead toward the rear of the connector.
NOTICE:
Removal of the terminal from housing cavity will cause
damage to the wire seal section, deteriorating
waterproofing performance. Replace the connector
with a new one.
NOTICE:
Do not insert the special tool into the female terminal
box. If you do so, replace the terminal with the new one
whether the terminal is broken or not.
NOTICE:
As for Non–waterproof type TLC housing, insert the
special tool into the housing from wire harness side.
Wire Harness Repair Manual (RM1022E)