Toyota Automobile Electrical Repair And Modification page 37

TERMINAL AND CONNECTOR REPAIR–TERMINAL REPLACEMENT
Retainer
(Yellow)
Seal rubber
Condition of cover opening
Side Lock
Center Lock
Type H (For 1.0II Type Connector)
(1)
NOTICE:
Do not insert the special tool into areas except
notches. (This may damage the seal ring that is
attached behind the retainer.)
(2)
Notch
NOTICE:
D Do not remove the seal rubber when pulling the
terminal out.
D If the seal rubber is peeled off when puling the
terminal out, press it down to stick it to the original
condition.
D Be sure and not fit the connector when the retainer
is not installed.
Type I (For SFPC Type Connector)
(1)
(2)
Side Lock
(3)
(4)
NOTICE:
D Following the above order is not required.
D No center lock on the housing with ten poles.
Wire Harness Repair Manual (RM1022E)
Move the special tool into the notch of the retainer to
the direction of the arrow with the edge of the housing
as the fulcrum. Then the pull the retainer out.
As same as the procedure (1), pull the retainer
straight out using hand after releasing the lock on the
other side.
Open the cover (white)
Remove the side lock of the retainer. (One side)
Remove the center lock of the housing.
Remove the side lock of the retainer. (The other side)
B–19
35