Toyota Automobile Electrical Repair And Modification page 67

TERMINAL AND CONNECTOR REPAIR–HOW TO INSTALL AND REMOVE SPECIAL CONNECTORS
Lever
Lever is not locked
2. Connect the connector
(1)
(2)
(3)
[Case 3]
1. Cut the connection of the connector
(1)
(2)
Lever
(3)
Wire Harness Repair Manual (RM1022E)
Connect the connector in the condition that the lever
is fully lifted up.
Hold the connector to prevent it from slip off and push
it down until you hear a click to lock it.
Confirm that the lever is securely locked.
Pick the part indicated in the illustration by fingers.
The lock is released and the lever is lifted up.
Lift the lever up fully.
B–49
65