B–50
TERMINAL AND CONNECTOR REPAIR–HOW TO INSTALL AND REMOVE SPECIAL CONNECTORS
Lever
Lever is not locked
66
(4)
Cut the connection of the connector.
NOTICE:
Do not hold the wire harness to pull it.
2.
Connect the connector
(1)
Connect the connector in the condition that the lever
is fully lifted up.
HINT:
If the lever is locked at the lower position, follow
the procedure [Case 3]. (1) to (3) and lift the lever up fully.
(2)
Hold the connector to prevent it from slip off and push
it down until you hear a click to lock it.
(3)
Confirm that the lever is securely fitted
Wire Harness Repair Manual (RM1022E)