Table of Contents
Advertisement
installation
|
16
1. Construct the wood framing, ensure the inside dimensions is
63" W x 50-1/*4" H
50-1/4"
2. Bend both nailing strips from the sides of the appliance until positioned
as shown below.
Determine the overall combined thickness of the non-combustible board
+finished material being used. The nailing strips can be adjusted 3-1/8".
3. Adjust nailing strips by loosening 2 screws on each nailing strip - adjust
and retighten the screws
4. Attach both vertical studs and secure using 6 screws (2 at bottom, 2 at
top and 2 on the sides) as shown
note: Ensure the flat side of the steel stud is facing the wood framing.
16 |
Regency Horizon HZ54E-10 Gas Fireplace
optional fraMinG kit
5. Secure horizontal steel header with 2 screws per diagram
6. Slide the unit in position. Hook up gas, venting and electrical and fan (if
purchased) prior to installing the remaining horizontal steel studs.
7. Secure 3 horizontal steel studs with 2 screws on each end. 2 at the top and
one at the bottom as shown.
1
2
3
Advertisement
Table of Contents
