Table of Contents
Advertisement
The valve cover will need to be removed to access the valve tray (see valve
tray replacement) and also to access the DBFC (see Battery + ON/OFF
switch installation).
1) Remove Faceplate and glass door if installed.
2) The valve cover is located on the right side underneath the glass door -
loosen 2 screws securing the valve cover (see Diagram 1 below).
Valve cover
3) Slide the valve cover upward.
ValVe coVer reMoVal
Diagram 1
Diagram 2
4) Lift the cover up off the screws and out of the unit.
5) To install - reverse steps.
Regency Horizon HZ54E-10 Gas Fireplace
installation
Diagram 3
|
33
|
33
Advertisement
Table of Contents
