Datamax W-Class Maintenance Manual page 80

4. Position the Drive Motor Assembly for mounting in the printer and re-route the Timing Belts around
the proper pulleys.
5. Start, but do not tighten both Motor Bracket Mounting Screws and the Lower Belt Tensioner Screw.
6. Reattach the Tensioner Springs to both the Upper and Lower Tensioner assemblies.
7. After ensuring that the Timing Belts are properly placed, tighten both Motor Bracket Mounting
Screws and the Lower Belt Tensioner Screw.
8. Tighten the screws on the Upper Belt Tensioner.
9. Reconnect the Drive Motor harness to connector J6 on the power supply board.
10. Replace the Electronics Cover; see Section 4.1.
Removal and Replacement
4-10