Ppp Interface Edit Screen - ZyXEL Communications ZyWall USG 50-H Series User Manual

Unified security gateway
Table of Contents

Advertisement

1 You must set up an account with your ISP and configure the PPPoE/PPTP interface with
your account's settings.
2 You do not set up the subnet mask or gateway.
PPPoE/PPTP interfaces are interfaces between the ZyWALL and only one computer.
Therefore, the subnet mask is always 255.255.255.255. In addition, the ZyWALL always
treats the ISP as a gateway.
At the time of writing, it is possible to set up the IP address of the gateway (ISP) using CLI
commands but not in the web configurator.
Click Network > Interface > PPP to open the following screen. This screen lists the PPPoE/
PPTP interfaces configured on the ZyWALL.
Figure 136 Network > Interface > PPP
Each field is described in the table below.
Table 50 Network > Interface > PPP
LABEL
#
Name
Base Interface
Modify
Apply
Reset

8.6.1 PPP Interface Edit Screen

This screen lets you configure new or existing PPPoE/PPTP interfaces. To access this screen,
click the Edit icon in the PPP Interface screen. The PPP interface Edit > Configuration
screen is shown here as an example. You can click the Wizard tab instead to configure just the
key settings. See
ZyWALL USG 50-H User's Guide
DESCRIPTION
This field is a sequential value, and it is not associated with any interface.
This field displays the name of the interface.
This field displays the interface on the top of which the PPPoE/PPTP interface
is.
This column lets you edit, activate, deactivate, connect and disconnect
interfaces.
To edit an interface, click the Edit icon next to it. The PPPoE/PPTP Interface
Add/Edit screen appears.
To activate or deactivate an interface, click the Active icon next to it. Make sure
you click Apply to save and apply the change.
To connect or disconnect an interface, click the Connect icon next to it. You
might use this icon to test the interface or to manually establish the connection
for a Dial-on-Demand PPPoE/PPTP interface.
Click Apply to save your changes back to the ZyWALL.
Click Reset to begin configuring this screen afresh.
Section 8.5 on page 162
for details.
Chapter 8 Interface
167

Advertisement

Table of Contents
loading

Table of Contents