ZyXEL Communications ZyWall USG 50-H Series User Manual page 188

Chapter 8 Interface
Table 60 Network > Interface > WLAN > Add (No Security) (continued)
LABEL
Interface Name Specify a number from 1~8 to complete the name for this wireless LAN interface.
Description
Zone
Virtual Access
Point Settings
SSID
Hide SSID
Broadcast
Block Intra-
BSS Traffic
Maximum
Associations
WLAN Security
Settings
Security Type
802.1x
RADIUS
Server IP
Address
RADIUS
Server Port
RADIUS
Server Secret
IP Address
Assignment
IP Address
Subnet Mask
Interface
Parameters
Egress
Bandwidth
Ingress
Bandwidth
188
DESCRIPTION
Enter a description of this interface. It is not used elsewhere. You can use
alphanumeric and
()+/:=?!*#@$_%-
characters long.
Select the zone to which you want the WLAN interface to belong.
(Service Set IDentity) The SSID identifies the Service Set with which a wireless
station is associated. Wireless stations associating to the access point (AP) must
have the same SSID. Enter a descriptive name (up to 32 printable 7-bit ASCII
characters) for the wireless LAN.
Select to hide the SSID in the outgoing beacon frame so a station cannot obtain
the SSID through scanning.
Select this to prevent wireless clients in this profile's BSS from communicating
with one another.
Specify the highest number of wireless clients that are allowed to connect to the
wireless interface at the same time.
Click Advanced to display more settings. Click Basic to display fewer settings.
Use this field to select the type of security to use for this wireless LAN interface.
Select none to not use any security. See the following sections for details on the
other security types.
Authentication server (IEEE 802.1x) settings are available when you use no
security or WEP security and click Advanced.
Select the check box to enable wireless user authentication through an external
authentication server.
Enter the IP address of the external authentication server in dotted decimal
notation.
Enter the RADIUS server's listening port number (the default is 1812).
Enter a password (up to 31 alphanumeric characters) as the key to be shared
between the external authentication server and the ZyWALL. The key is not sent
over the network. This key must be the same on the external authentication
server and ZyWALL.
Enter the IP address for this interface.
Enter the subnet mask of this interface in dot decimal notation. The subnet mask
indicates what part of the IP address is the same for all computers in the network.
Click Advanced to display more settings. Click Basic to display fewer settings.
Enter the maximum amount of traffic, in kilobits per second, the ZyWALL can
send through the interface to the network. Allowed values are 0 - 1048576. This
setting is used in WAN load balancing and bandwidth management.
This is reserved for future use.
Enter the maximum amount of traffic, in kilobits per second, the ZyWALL can
receive from the network through the interface. Allowed values are 0 - 1048576.
characters, and it can be up to 60
ZyWALL USG 50-H User's Guide