ZyXEL Communications ZyWall USG 50-H Series User Manual page 56

Chapter 4 Wizard Setup
Figure 20 PPPoE Encapsulation: Static
The following table describes the labels in this screen.
Table 10 PPPoE Encapsulation: Static
LABEL
ISP Parameters
Encapsulation
Service Name
User Name
Password
Retype to
Confirm
Nailed-Up
Idle Timeout
WAN IP Address
Assignments
WAN Interface
Zone
IP Address
DNS (Domain Name System) is for mapping a domain name to its corresponding IP address and vice
versa. The DNS server is extremely important because without it, you must know the IP address of a
computer before you can access it. The ZyWALL uses a system DNS server (in the order you specify
here) to resolve domain names for VPN, DDNS and the time server.
56
DESCRIPTION
This displays the type of Internet connection you are configuring.
Type the PPPoE service name given to you by your ISP. PPPoE uses a service
name to identify and reach the PPPoE server. You can use alphanumeric and -
_ @$./ characters, and it can be up to 64 characters long.
Type the user name given to you by your ISP. You can use alphanumeric and -
_ @$./ characters, and it can be up to 31 characters long.
Type the password associated with the user name above. Use up to 64 ASCII
characters except the [] and ?. This field can be blank.
Type your password again for confirmation.
Select Nailed-Up if you do not want the connection to time out.
Type the time in seconds that elapses before the router automatically disconnects
from the PPPoE server. The default time is 100 seconds.
This displays the identity of the interface you configure to connect with your ISP.
This field displays to which security zone this interface and Internet connection will
belong.
Enter your WAN IP address in this field.
ZyWALL USG 50-H User's Guide