ZyXEL Communications ZyWall USG 50-H Series User Manual page 178

Chapter 8 Interface
Table 55 Interface > Cellular > Status (continued)
LABEL
Status
Service Provider
Cellular System
Signal Quality
More Info.
178
DESCRIPTION
No device - no 3G device is connected to the ZyWALL.
Device detected - displays when you connect a 3G device.
Device error - a 3G device is connected but there is an error.
Probe device fail - the ZyWALL's test of the 3G device failed.
Probe device ok - the ZyWALL's test of the 3G device failed.
Init device fail - the ZyWALL was not able to initialize the 3G device.
Init device ok - the ZyWALL initialized the 3G card.
Check lock fail - the ZyWALL's check of whether or not the 3G device is locked
failed.
Device locked - the 3G device is locked.
SIM error - there is a SIM card error on the 3G device.
SIM locked-PUK - the PUK is locked on the 3G device's SIM card.
SIM locked-PIN - the PIN is locked on the 3G device's SIM card.
Unlock PUK fail - Your attempt to unlock a WCDMA 3G device's PUK failed
because you entered an incorrect PUK.
Unlock PIN fail - Your attempt to unlock a WCDMA 3G device's PIN failed
because you entered an incorrect PIN.
Unlock device fail - Your attempt to unlock a CDMA2000 3G device failed
because you entered an incorrect device code.
Device unlocked - You entered the correct device code and unlocked a
CDMA2000 3G device.
Get dev-info fail - The ZyWALL cannot get cellular device information.
Get dev-info ok - The ZyWALL succeeded in retrieving 3G device information.
Searching network - The 3G device is searching for a network.
Get signal fail - The 3G device cannot get a signal from a network.
Network found - The 3G device found a network.
Apply config - The ZyWALL is applying your configuration to the 3G device.
Inactive - The 3G interface is disabled.
Active - The 3G interface is enabled.
Incorrect device - The connected 3G device is not compatible with the ZyWALL.
Correct device - The ZyWALL detected a compatible 3G device.
Set band fail - Applying your band selection was not successful.
Set band ok - The ZyWALL successfully applied your band selection.
Set profile fail - Applying your ISP settings was not successful.
Set profile ok - The ZyWALL successfully applied your ISP settings.
PPP fail - The ZyWALL failed to create a PPP connection for the cellular
interface.
Device ready - The ZyWALL successfully applied all of your configuration and
you can use the 3G connection.
This displays the name of your network service provider or Limited Service
when the signal strength is too low.
This field displays what type of cellular network the 3G connection is using. The
network type varies depending on the 3G card you inserted and could be UMTS,
UMTS/HSDPA, GPRS or EDGE when you insert a GSM 3G card, or 1xRTT,
EVDO Rev.0 or EVDO Rev.A when you insert a CDMA 3G card.
This displays the strength of the signal. The signal strength mainly depends on
the antenna output power and the distance between your ZyWALL and the
service provider's base station.
This field displays other details about the 3G connection.
ZyWALL USG 50-H User's Guide