Installation note: Make sure to attach the ground cable to the screw (see step 5 from previous page).
Warning: Whenever you replace the ADF (entire), the flatbed scanner, or the MDC card, perform the
Manual Registration"
To enter Config Menu:
Turn off the multifunction printer.
1.
2.
Press and hold buttons 2 and 6.
Turn on the MFP.
3.
Release the buttons when the progress bar displays.
4.
ADF case assembly removal
1.
Remove the ADF front cover. See
Disconnect the sensor cable (A).
2.
in Configuration menu.
"ADF front cover removal" on page
7526
"Scanner
4-217.
Repair information
4-239
Previous
Next
Go Back