Enforce Color Order; Color Alignment; Color Adj State - Lexmark X746de Service Manual

Enforce Color Order

This setting gives the system support person the ability to enforce where the color cartridges may be placed,
and if messages appear when cartridges are in the wrong location.
When On (default) is selected, the printer lets users place each toner cartridge in only its specified slot. For
instance, the Magenta toner cartridge must be in the Magenta slot. If the user tries to place a cartridge in an
incorrect slot, the printer message 31 Defective or Missing <color> Cartridge or 32 Unsupported <color>
Cartridge appears where <color> stands for Cyan, Magenta, Yellow, or Black.
When Off is selected, the printer does not issue any message to let the user know that the cartridge is placed in
the wrong slot inside the printer.
To adjust the Enforce Color Order setting:
1. Touch Enforce Color Order from the Configuration Menu.
Touch the
2.
3. Touch Submit.
Submitting changes... is displayed.
You are automatically returned to the Configuration menu.

Color Alignment

Color alignment should be performed when the transfer module is replaced.
To perform color alignment:
Touch Color Alignment from the Configuration Menu.
1.
2. Touch Print Alignment.
Four pages print with charts and letters A–L.
Consulting the printed page, look at Set A.
3.
Indicate the number of the 20 color lines closest to the black lines.
Enter that number on the operator panel using the left and right arrows.
4.
5. Continue selecting the best lines for the sets through Set L and entering them on the operator panel.
Touch Submit when all are entered.
6.
Submitting changes... is displayed.
You are automatically returned to the Configuration menu.

Color Adj State

These settings allow you to select when color calibrations occur. Selecting Busy indicates the color calibrations
will complete queued jobs, but refuse to add new jobs to the queue. When calibration is complete jobs are again
accepted. Selecting Idle allows calibrations only when the printer is idle.
To adjust the Color Adj State setting:
Touch Color Adj State from the Configuration Menu.
1.
2. Touch the
Touch Submit.
3.
Submitting changes... is displayed.
You are automatically returned to the Configuration menu.
or arrow to toggle between Off and On (default).
or arrow to toggle between Busy and Idle.
7526
Previous
Go Back
Diagnostic aids
3-39
Next