Photoconductor Unit Removal - Lexmark X746de Service Manual

Photoconductor unit removal

Note: This is not a FRU.
Warning: To avoid damaging the photoconductor drum, hold the photoconductor units by their handle and
place the photoconductor units on a clean surface. See
page 4-3
Open the front access door.
1.
Lift the right end handle (A) of the photoconductor unit, releasing from the mount.
2.
3. Lift the unit up and away from the left side of printer, ensuring the left end of the photoconductor is released
from the holding pin (B).
B
Installation note: If a new photoconductor unit is installed, reset the life count value in the printer memory.
If a message appears on the operator panel:
•
When 84 <color> PC Unit Life Warning or 84 Replace <color> PC Unit appears, touch Supply
1.
Replaced.
Replace Supply displays.
Touch Cyan PC Unit, Magenta PC Unit, Yellow PC Unit, or Black PC Unit based on the
2.
photoconductor unit that was just replaced.
<color> PC Unit Replaced displays.
Touch Yes to clear the message.
3.
If no message appears:
•
1. Touch Menus.
Touch Supplies Menu.
2.
Touch Replace Supply.
3.
Touch Cyan PC Unit, Magenta PC Unit, Yellow PC Unit, or Black PC Unit based on the
4.
photoconductor unit that was just replaced.
<color> PC Unit Replaced displays.
Touch Yes.
for additional information.
"Handing the photoconductor unit" on
Repair information
7526
Previous
Next
Go Back
A
4-145