Lexmark X746de Service Manual page 51

Error code Action
Restore Held Jobs If the printer detects Print and Hold (or parked) jobs stored on the hard disk during Power-On
Go/Stop? Self Test (POST). Choices are:
Securely Clearing Disk Disk wiping process is recovering disk space. The message clears when all memory blocks
Space are cleared.
Tray Length Guide Replace the tray length guide.
Missing
Unsupported USB Remove the unrecognized device to continue.
device, Please Remove
Unsupported USB hub, Remove the unrecognized device to continue.
Please Remove
Unsupported Mode Unplug camera and change it to a mode where the camera can access PictBridge. Plug the
camera back in to continue.
Unsupported Disk Remove the unsupported disk to continue.
3x through 8x attendance messages
31 Defective or Missing
<color> Cartridge
32 Unsupported
Cartridge
• Restore—Print jobs are restored, and Restoring Held Jobs x/y, where x is the number
of the job restored and y is the total number of jobs to restore. You can quit restoring, and
the remainder of the jobs will remain on the disk, but cannot be accessed until they are
restored at the next POR.
• Do not restore—Held jobs will remain on the disk, but cannot be accessed until they are
restored at the next POR. Held jobs may not be restored appears.
• Tell me more—additional information is available
• Reseat the specified toner cartridge.
• Inspect the smart chip card contacts (A) for damage, contamination or positioning error. If
damaged, contact your next level of service.
• Inspect the toner cartridge contacts for damage/contamination. Replace the toner
cartridge if defective.
• Replace the indicated cartridge.
• If the problem still exists, see
• Check to see if the toner cartridge is a supported cartridge.
Note: Once the cartridge shipped with the printer is exhausted, it must be replaced by a
supply cartridge (refer to the User's Guide for part numbers.)
If the specified toner cartridge is a supported cartridge, reseat the cartridge.
• Inspect the toner cartridge contacts for damage or contamination. Replace the toner
cartridge if defective.
• Inspect JSBTN1 cable connection. Properly connect the cable if not connected properly.
Replace the cable if damaged.
• If the problem still exists, replace the system board. See
page 4-165.
A
"31.xx—Cartridge errors service check" on page
"System board removal" on
7526
2-46.
Diagnostic information
2-11
Previous
Next
Go Back