Disable Scanner; Automatic Color Adjust; Auto Align Adj - Lexmark X746de Service Manual

7526

Disable Scanner

If a scanner is not working, the scanner can be disabled, allowing the user to continue using the printer portion of
the multiple function printer. Disable disables the entire scanner (ADF and flatbed), and then users attempting
to use the scanner function receive Scanner disabled by administrator message. ADF Disabled disables
only the ADF, but the flatbed continues to function. Users will receive a Automatic document feeder disabled
by administrator message, and the paper present sensor in the ADF reports empty. Enabled turns the
scanner back on, and is the default setting.
Auto Disabled is not a selection. It appears in response to certain scanner operation failures, and indicates the
scanner is already disabled. Submit is disabled when it appears.
To disable the scanner:
Touch Disable Scanner from the Configuration Menu.
1.
Touch the
2.
Auto Disabled appears in response to certain scanner operation failures.
Touch Submit.
3.
Submitting changes... is displayed.
You are automatically returned to the Configuration menu.

Automatic Color Adjust

Sets the suggested number of pages which the printer should print between consecutive calibrations.
If the printer exceeds the set value while printing a job, it completes the current job and any other jobs received
while printing the current job before it initiates a calibration. The printer does not cancel or suspend an active job
in order to perform a calibration. If a user is in any of the menus, including the Configuration Menu and the
Diagnostics mode, an automatic color adjust calibration does not occur.
Touch Auto Color Adjust from the Configuration Menu.
1.
2. Touch decrease the value or
Selections are Off and the values between 100 and 1000 in increments of 50. The default is 500 pages.
3. Touch Submit.
Submitting changes... is displayed.
You are automatically returned to the Configuration menu.

Auto Align Adj

Controls whether the printer executes the automatic alignment calibration after an initiating event occurs. When
an event initiates a TPS operation, the printer performs a toner density calibration, (TPS) an alignment
calibration, or both of the calibrations.
Toner Patch Sensing (TPS) is a diagnostic mechanism that automatically adjusts the printer toner density and
alignment settings. When TPS executes, the printer generates toner patches on the transfer belt. It then uses
these to calculate the appropriate adjustment, to density, if necessary.
To adjust the Auto Align Adj setting:
Touch Auto Align Adj from the Configuration Menu.
1.
Touch the
2.
3. Touch Submit.
Submitting changes... is displayed.
You are automatically returned to the Configuration menu.
Service Manual
3-38
or arrows to select Enabled (default), Disabled, or ADF Disabled.
to increase the value.
or arrow to toggle between Off and On (default).
Previous
Next
Go Back