Ricoh G165 Service Manual page 223

1) The previous MUSIC was done if there was a high temperature inside the
machine.
3. Immediately after the front or top cover is closed
No adjustment is done when the front or top cover is closed, if one of the following
conditions occurs.
1) After paper jam detection and New AIO detection
2) New ITB unit detection (after transfer unit life counter is reset with SP mode)
3) No environment change
Toner amount control and MUSIC start automatically when the front or top cover is
closed, if conditions other than described above occur.
4. Ready status:
Toner amount control and MUSIC start automatically when the machine stays in
the ready condition and the environment has changed.
5. Before a job:
MUSIC starts automatically before a job if the previous MUSIC was done when
there was a high temperature inside the machine and a specified time has
elapsed.
MUSIC starts automatically before a job if the machine is turned on in a low
temperature condition and a specified time has elapsed.
6. Page end:
Toner amount control and MUSIC start automatically between pages when the
machine detects an environment change.
Toner amount control and MUSIC start automatically between pages when the
machine has copied/printed 200 pages since the previous process control.
Toner amount control and MUSIC interrupt a job and start automatically between
pages when the machine has copied/printed 250 pages since the previous
process control.
MUSIC starts automatically between pages when the machine has copied/printed
100 pages in the same job since the previous process control.
MUSIC starts automatically between pages when the polygon motor has been
rotating for 180 seconds.
MUSIC interrupts a job and starts automatically between pages when the polygon
motor has been rotating for 300 seconds.
SM
CÓPIA NÃO CONTROLADA
6-15
CÓPIA NÃO CONTROLADA
Process Control
G165/G166/G167/G181/G183/G184